To Fill Fuel; Operation - Husqvarna W50P Manuel D'utilisation

5. If the discharge hose (D) must be installed across a
road, put it perpendicular to the flow of the traffic. Put
long wooden blocks (E) on the 2 sides of the
discharge hose for protection.
E
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
• Make sure that the product is on level ground.
• Make sure that the ON/OFF switch is in the OFF
position.
• Examine the product for damages. Make sure that
there are no fuel or oil leaks.
• Remove unwanted material from the product. Clean
carefully around the muffler and the starter unit.
• Make sure that all nuts, bolts, screws and hose
connectors and clamps are tight.
• Make sure that there is no damage on the suction
hose or discharge hose.
• Make sure that the sealing washer and strainer on
the suction hose connector is installed correctly and
not damaged.
• Do a check of the fuel and oil levels. An oil level that
is too low can cause damage to the product.
• Do a check of the air filter. Refer to
the air filter on page 12 .

To fill fuel

Use unleaded gasoline with octane number not less
than 90 RON (87 AKI).
CAUTION:
contamination in the gasoline and do not
use a mixture of oil and gasoline. Dirt or
8
D

Operation

Read and understand the
To do a check of
Make sure that there is no
water in the fuel tank can cause damage to
the product.
1. Stop the engine and let the product become cool.
To stop the product on page 10 .
Refer to
2. Make sure that the product is on level ground and in
an area with good air flow.
3. Remove the fuel tank cap.
4. Carefully fill the fuel tank to 25 mm/1 in. below the
top of the fuel tank (A).
5. Clean the product from fuel spillage.
CAUTION:
and can cause damage to the
environment.
To fill the product with water
Before operation, it is necessary to fill the product with
water to prevent damage to the product.
A
Fuel spillage is a fire risk
1421 - 004 - 09.07.2020