WIFIDW10WT
Water detector
Description
1. Status indicator
2. Reset button
3. Probe
4. Probe interface
5. Mounting bracket
Use
1. Download and install the app "Nedis SmartLife" from
Apple App Store or Google Play Store on your mobile
device.
2. Launch the app "Nedis SmartLife".
3. Create a new account or log in to your existing
account.
4. Tap "+" to add the device.
5. Select "Other products" from the list of products.
6. Open the water detector by turning the top half of
the device counterclockwise.
7. Install the battery.
8. If the status indicator does not flash: Press and hold
the reset button for 6 seconds.
If the status indicator flashes: Confirm in the app.
9. Confrm the Wi-Fi network and password.
10. Enter the device name.
Note: The device name will also be used for push
notifications.
11. Install the mounting bracket to a vertical surface
using the screws. Maximum height: 1 m above floor
level.
12. Place the water detector into the mounting bracket.
13. Plug in the probe. Place the probe where the water
detector needs to detect the presence of water.
Safety
•
To reduce risk of electric shock, this product should
only be opened by an authorized technician when
service is required.
•
Read the manual carefully before use. Keep the
manual for future reference.
•
Only use the device for its intended purposes. Do not
use the device for other purposes than described in
the manual.
•
Do not use the device if any part is damaged or
defective. If the device is damaged or defective,
replace the device immediately.
•
The device is suitable for indoor use only. Do not use
the device outdoors.
Cleaning and maintenance
Warning!
•
Do not use cleaning solvents or abrasives.
•
Do not clean the inside of the device.
•
Do not attempt to repair the device. If the device
does not operate correctly, replace it with a new
device.
•
Clean the outside of the device using a soft, damp
cloth.
Support
If you need further help or have comments or
suggestions please visit www.nedis.com/support
3
English