Operating Instructions - Silhouette Select DAR154BLSST Guide D'utilisation

Please use the cabinet under 5-35°C ambient temperature, if the ambient temperature is higher than or
lower than this temperature, it will cause the temperature fluctuation in the cabinet, maybe can't
reach 2-10°C.
CONTROL PANEL
INSTRUCTIONS
Indicator light illuminates to signify the cooling mode
is currently in operation.
Control the interior light ON/OFF.
To turn on/off appliance( press and hold this button
for approximately 3 seconds).
Used to raise(warm) the temperature by 1°C.
Used to lower (cool) the temperature by 1°C.
(°C / °F) Adjacent indicator light denotes which scale of
temperature is displayed.
SETTING THE TEMPERATURE
CONTROLS
When you plug in your refrigerator for the first time the
temperature will automatically be set to 41 °F (5°C) and
will be displayed in the Fahrenheit scale (°F)
• The temperature range can be set as low as 36 °F
(2°C) or as high as 50°F (10°C) to suit your specific
storage requirements. Each depression of the
buttons will allow you adjust the temperature in 1°
degree increments within the aforementioned range.
• To switch the display between the Fahrenheit (°F) and
Celsius (°C) scale, depress the
simultaneously for approximately 3-5 seconds.

OPERATING INSTRUCTIONS

buttons
FUNCTIONS
Temperature Memory Function
• If all of a sudden the power is lost, the set temperature
will be saved by the unit and once the power is back on
the unit will be at the same set temperature.
Door Close Reminding Function
• When you forget to close the door or the door is not fully
closed, there will be warning alarm after 5 minutes.
Temperature Alarm Function
• If inner temperature is higher than 73°F (23°C). The "HI"
is shown in display panel and the alarm will sound. It
informs you that the inner temperature is too high,
please check the reason.
• If inner temperature is lower than 34°F (1°C), the "LO" is
shown in display panel and the alarm will sound as well
the malfunction indicator light will illuminate.
SHELVES
IMPORTANT!
Do not cover the gap on the glass shelves with alu-
minum foil or any other material that will prevent ade-
quate air circulation within the cabinet.
When removing any of these shelves out of the rail com-
partment, you must first disassemble and remove the
plastic posts then remove the Lock screws that hold each
post in place.(Fig A)
To re-install, ensure the shelf is resting securely on the
support brackets and push shelf inward until it locks into
place.
Caps
4
Plastic
Lock
Posts
Screws
Fig A.