marposs E86N Manuel D'installation Et D'utilisation page 74

ENGLISH
number of switch on/switch off attempts: the first 2 digits indicate the text "nr".
the third cyclically assumes values from 2 to 9 (default is 4).
this data item allows programming of the maximum number of attempts that the base station makes to switch the
transmitter on/off. when said number of attempts is reached, if the transmitter has not be switched on/off, the interface
must be provided with a new command by means of the start signal.
increasing the number of attempts causes a significant delay in the switch on/switch off time.
for the default value (nr=4) the switch on/switch off times are as shown in the table:
TYPICAL
1.050 sec
1.200 sec
1.350 sec
1.500 sec
if the number of attempts is changed the values in the table are modified according to this equation:
delay = default delay x (nr / 4)
as shown in the table, the switch on/switch off time also depends on the identification code used (sub-channel).
the greater the distance between the codes, the smaller the probability of switch on/switch off failure, in situations with
high density close applications.
Confirm data programmed: The first digit shows "P". The third cyclically takes the values <0> for do not programme
the interface and <1> for program the interface.
74
MAX. VALUE
4.200 sec
4.800 sec
5.400 sec
6.000 sec
IDENTIFICATION CODE
A
B
C
D
E86N- Touch system with radio transmission