Beka LED bkl-dataleddriver Manuel D'utilisation page 11

User manual
2.5 Operation
IC type, RGB order and pixel length length setting
• You must first assure IC type, RGB order and pixel length of the LED strip is correct
• Long press M and < key, prepare for setup IC type, RGB order, pixel length, automatic blank screen.
Short press M key to switch four item. Press < or > key to setup value of each item. Long press M
key for 2s, or timeout 10s, quit setting.
• IC type table:
No.
C11 TM1803
C12 TM1809, TM1804, TM1812, UCS1903, UCS1909, UCS1912,
UCS2903, UCS2909, UCS2912, WS2811, WS2812, SK6812
C13 TM1829
C14 TLS3001, TLS3002
C15 GW6205
C16 MBI6120
C21 LPD6803, LPD1101, D705, UCS6909, UCS6912
C22 LPD8803, LPD8806
C23 WS2801, WS2803
C24 P9813
• RGB order: O-1 – O-6 indicate six order (RGB; RBG, GRB, GBR, BRG, BGR).
• Pixel length: Range is 008-1024, b00-b24 indicate 1000-1024.
• Automatic blank screen: enable ("bon") or disable ("boF") automatic blank screen.
DMX mode
• Short press M key, when display 001-999, enter DMX mode.
• Press < or > key to change DMX decode address (001-999), long press for fast adjustment.
• Long press M key for 2s, prepare for setup decode number and multiple of pixels. Short press M
key to switch two item. Press < or > key to setup value of each item. Decode number (display
"dno"): DMX decode channel number, range is 003-900. Multiple of pixels (display "Pno"): Each 3
DMX channel control length, range is 001-100. Long press M key for 2s, or timeout 10s, quit setting.
IC type
Data LED Driver
Output signal
DATA
DATA
DATA
DATA
DATA
DATA
DATA, CLK
DATA, CLK
DATA, CLK
DATA, CLK
11