Battipav QUEEN 180 Mode D'emploi page 21

Battipav srl
INSTALLATION
TRANSPORT
1 The QUEEN-MAGIK can be transported easily through the side handle.
HANDLING
Remove the machine from the packaging and check that no parts have been damaged.
Place the machine on a stable surface free of other material.
2
POSITION THE BLADE GUARD APPROXIMATELY HALF A CENTIMETRE ABOVE THE TILE SURFACE
THROUGH THE KNOB. LOCK THE BLADE GUARD IN POSITION BY FULLY TIGHTENING THE SCREW
ILLUSTRATED IN THE FIGURE.
CHECKING BEFORE USE
THE MACHINE MOD. 718/818 HAS BEEN DESIGNED FOR WORKING EXCLUSIVELY WITH WATER.
3
Before and during cutting operations, make sure that the water level is the same as the one indicated in the relevant label
located on the machine side. Fill or top up the basin directly, as shown in the figure.
In particular cases, it may be necessary to use a basin to recover the cooling water. If so, it is recommended to use
a basin with the following dimensions: L 50 CM, P 60 CM, H 10 CM
CONNECTING TO POWER SUPPLY
THE MACHINE IS TO BE CONNECTED TO THE POWER SUPPLY BY A RESIDUAL CURRENT CIRCUIT BREAKER
(RCCB) WITH THE FOLLOWING CHARACTERISTICS:
RCCB In 16 A Id 30 mA
N.B. To ensure correct functioning, periodically check the efficiency of RCCBs by pressing the push-button on the front of the device.
• Make sure that the section of the power supply cable cores has been measured according to the starting current and its length.
For cables up to 50 m long, a section of 2,5 mm
• Before connecting the machine to the power socket, check that the power supply voltage corresponds to that shown on the
plate on the machine.
• The machine must be connected to an effective earth wire. In case of doubt, do not connect the machine.
BLADE ASSEMBLY / DISASSEMBLY
Remove the blade guard.
4
Use the 4 mm. Allen wrench to hold the motor shaft. Unscrew the blade flange block nut with the 19 mm wrench.
AFTER REMOVING THE BLADE, CLEAN THE BLADE FLANGE THOROUGHLY AND CHECK FOR WEAR.
LUBRICATE SURFACES WITH FINE OIL, THEN FIT THE BLADE.
CHECK DAMAGED PARTS
Before further use of tool, it should be carefully checked to determine that it will operate properly and perform its intended function.
For diamond blade disassembly, perform the opposite operations.
CONTROL DEVICES
5
The QUEE-MAGIK machine is equipped with a control board made up of:
1) START BUTTON: (GREEN COLOUR)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.
3) DEVICE FOR DISCONNECTION FROM THE MAINS (Power supply cable with plug):
Machine power supply point.
CUTTING ON THE TABLE
6
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT AT LEAST 150 cm
ARE LEFT FREE AROUND THE MACHINE (See picture 6). IN ORDER TO WORK IN SAFETY CONDITIONS, DO
NOT LET OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING OPERATIONS.
7
BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE MATERIAL IS PROPERLY LEANED AGAINST
THE TILE STOPPER.
Position the cutting guide, then lock it by tighten the knobs fully.
7
Figure 7 shows the correct hand position during 90° cutting operations.
The forward movement of the piece must be proportional to the blade cutting capacity,
to prevent hazardous fragments which could cause accidents or injuries from breaking off.
is enough.
2
GB
21