GE IM-4B Manuel D'utilisation Et D'installation page 10

ICEMAKER INSTALLATION INSTRUCTIONS (cont.)
INSTALL WATER LINE
13
Make sure there is enough plastic water line to
extend from the water valve to well into the water
tube inlet. Cut off any excess tubing.
Squeeze the ends of the hose clamp from the kit with
pliers and slide the clamp over the water tube inlet.
While still squeezing the clamp, insert the plastic water
line into the inlet as far as it will go (approximately 1"
(25 mm). Then slide the clamp downward to capture
the plastic water line in place. Make sure the fill tube
is aimed down.
Remove the adhesive backing on the opposite side of
the water fill tube seal and slide the tube into the hole
near the top at the back of the refrigerator. Firmly
press on the inlet to secure it to the refrigerator.
Note: Prior to use, verify water tube inlet is fully
seated in the fill cup.
Installation Instructions
Hose Clamp
13
Fill Tube
11
Fill Cup 12
INSTALL WATER LINE CLAMP
14
Attach the water tube inlet cover and water line
clamp to the refrigerator. Drive the screw from the
kit through the fixtures at the indent into the back of
the cabinet.
Phillips Head
Screws
ROUTE AND ATTACH THE WATER
15
TUBE
Fasten the plastic water tube to the back of the
refrigerator with adhesive-backed fasteners, spacing
the fasteners as shown to take up slack in the tube.
Water Tube Fastener
4
WATER VALVE INSTALLED
16
Once the home water line is connected to the water
valve and turned on, set the feeler arm to the ON
position.
The icemaking cycle will not begin until the
icemaker and
operating temperature, then icemaking will begin
automatically.
KEEP THIS MANUAL
17
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly section.
10
Water Tube
Inlet Cover
15
Water Line Clamp
freezer compartment
14
6
reach