Selecline 600081542 Manuel D'utilisation page 16

TROUBLESHOOTING
Caution! Before troubleshooting, disconnect the power supply. Any
troubleshooting beyond what is described below should be done by a qualified
electrician.
Important! There are some sounds during normal use, such as those from the
compressor and refrigerant circulation.
Problem
Appliance doesn't work.
Appliance freezes too
much.
The food is not frozen
enough.
Heavy build-up of front
on the door seal.
Possible Cause
Mains plug is not
plugged in or is loose.
Fuse has blown or is
defective.
Socket is defective.
Temperature is set too
cold or the appliance
runs at MAX setting.
Temperature is not
properly adjusted.
Door was open for an
extended period of
time.
A large quantity of
warm food was placed
in the appliance
within the last 24
hours.
The appliance is near a
heat source.
- Door seal is not
air-tight.
16
Solution
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are
to be corrected by an
electrician.
Turn the temperature
regulator to a warmer
setting temporarily.
Look in section on the
Temperature Setting
Recommendation.
Open the door only as
long as necessary.
Turn the temperature
regulator to a colder
setting temporarily.
Look in the Installation
Location section.
Carefully warm the
leaking sections of the
door seal with a hair
dryer on a cool setting.
While doing this, shape
the warmed door seal
by hand pushing it into
shape so that it seals
correctly.