Battery Monitor - M-E DGF-300 Mode D'emploi

DGF-300
| ENGLISH
Volume Setting
The battery compartment houses a volume
switch (6) which allows the volume to be set at
two levels.
The bell tone on the receiver can be switched
on and off by briefly pressing the "CODE" (2)
button. The blue light signal remains even when
the ring tone is switched off.

Battery Monitor

The DGF 300 has a wireless battery monitor.
If the receiver generates short audio bursts
approximately once per minute, this indicates the
batteries of the transmitter and/or the receiver
are dead and should be changed. If the TX-LED
flashes, the transmitter's batteries are dead. If
the RX-LED flashes, the receiver's batteries
are DEAD.
Coding and Expansion
Press and hold the 'CODE' button (2) on the
receiver for approx. 3 seconds until the red LED
(3) next to the button begins to flash. Then press
the 'CODE' button on the transmitter once briefly.
The red LED on the receiver will stop flashing
immediately and the melody will play. The
transmitter and receiver have now been encoded.
Repeat these steps for all transmitters / receivers
intended to work together. Also follow these
steps if there are overlaps with similar devices in
the neighborhood.
Close the battery compartment again once all
settings have been undertaken as you wish.
MOUNTING
You can position the transmitter and receiver
wherever you want using the included stands.
You can also mount the transmitter and receiver
on the wall. There are slot holes on the back of
the devices for this purpose. The diameter of the
screw head should not be more than 7 mm.
ACCESSORIES
A repeater (Mod. CUVEO CR-R1) is available
for this passage detector with which you can
increase the range by approx. 50 m (in an open
area).
TECHNICAL SPECIFICATIONS
Transmitter
Frequency:
Battery:
Energy Consumption: Standby ca. 1 mA,
Battery Life:
Mains Plug:
Range:
Dimensions (HxWxD): 150 x 115 x 28 mm
14
434 MHzz; < 10 mW
4x 1,5 V AA Mignon
(Alkaline)
Alarm ca. 20 mA
ca. 3 Months (Continuous
battery operation without
signal triggering)
6V / 100mA
5m / 360°, open air
range ca. 140°