Eluktronics PRO15SE Guide Utilisateur page 13

12. Type a name of your choice for your RAID volume and press
<Enter>.
Figure 2 -Name the RAID Volume (Advanced > Intel(R)
Rapid Storage Technology)
13. Go to RAID Level: and press <Enter>.
14. Choose the RAID Level required (see
press <Enter>.
• RAID 0 (Stripe)/RAID 1 (Mirror)/Recovery
15. Go to any of the disks listed under Select Disks: and select a
disk name and press <Enter>.
16. Move the cursor down (use the arrow keys) onto X (or select
the disk required) and press <Enter>.
If you have selected a Recovery level RAID then you
need to select one disk to be Master disk (M) and one
disk to be the Recovery disk (R).
17. You should select two identical disks to form your RAID volume.
18. If you have selected RAID 0 (Stripe) then you can adjust the
"Strip Size" to your requirements.
19. If you have selected Recovery then you can adjust the
Synchronization to "On Request" or "Continuous".
20. Go to Create Volume and press <Enter>.
21. The RAID volume will then be created and the RAID information
Table 2 on page 6) and
22. Press <Esc> to exit the menu.
23. Press <F4> and <Yes> to "Save Changes and Reset".
24. Make sure the Windows OS DVD is in the DVD drive and as
25. Click Next > Install Now to continue installing the operating
26. Follow the on-screen instructions to install the Windows
Figure 3
Select
27. Install the Windows drivers as per
Disks
will be displayed under Intel(R) Rapid Storage Technology (in
the Advanced menu).
the computer starts up it will automatically boot from the
Windows OS DVD (you will be prompted to press a key to boot
from the DVD).
system as normal (see your Windows documentation if you
need help on installing the Windows OS).
operating system.
sure you install the Intel® Rapid Storage Technology (IRST)
driver (see page 28).
Figure 4
RAID Informa-
tion (Advanced >
Intel(R) Rapid
Storage Technol-
ogy)
Table 5 on page 27. Make
7