Table des Matières
Publicité
Access your cables
There are two cable access covers on the enclosure that you can remove to access and
manage your cables.
1. To take off a cable access cover, use a Phillips type screwdriver to remove the two
screws on both ends of the cable access cover.
2. Pull the cable access cover away from the enclosure. (figure 4)
To put the cable access cover back on, place the cover over the cable access opening
and use a Phillips type screwdriver to insert the screws through the cover and into the
enclosure. Tighten the screws.
figure 4
Instruction manual
7
Publicité
Table des Matières
