BORETTI Windy/2 900 Mode D'emploi Et Installation page 10

GB
slightly to allow it to clamp around the brackets item 2. Secure the chimney stack to the brackets
using the four self tapping screws provided. Fit the lower chimney section item I by expanding the
chimney slightly to allow it to clamp around the upper chimney section item S, and the bracket on
top of the canopy item C as illustrated in fig. 5. Secure the chimney stack to the bracket using the
two self tapping screws provided.
12) Place the 3 metal grease filters as illustrated in fig. 11.
• RECIRCULATION
1) Fit the recirculation spigot item R over the round outlet on top of the canopy while pressing down on
the spigot until it snaps into position as illustrated in fig. 7.
Note : The two recirculation ducts item G must be fitted onto the recirculation spigot R before fitting
onto the canopy item C
2) Remove the metal grease filters and place one charcoal filter at a time over the grilles on either side
of the motor housing as illsutrated in fig. 6 & 8.
8