Starting And Stopping - Sandrigarden GBL 26 Mode D'emploi

GB
BRUSH CUTTERS OPERATING MANUAL
5. REFUELLING
1) CAUTION! The device is equipped
with a two-stroke engine.
The engine must be supplied with a mixture of petrol
and oil for two-stroke engines in the following ratios.
With normal oil for two-stroke engines
With synthetic oil for two-stroke engines 1:40 (2.5%)
2) Mix by stirring the container thoroughly before
refilling the tank.
Fig.25
3) Prepare the
fuel mixture and
only refuel
outdoors (fig.25).
4) Store the fuel in a container set aside for this
purpose and with tightly sealed cap.

6. STARTING AND STOPPING

CAUTION! Strictly heed the warnings
outlined in the chapter 2 above titled
ESSENTIAL SAFETY PRECAUTIONS.
COLD ENGINE STARTUP
1) Press the stop button (fig.26) to the "ON" position.
2) Lift the choke lever located to the right of the
carburettor cover (fig.27) and place it in the
position.
3) Repeatedly press the primer bulb (fig.28) down
until the fuel returns to the tank through the second
transparent hose (fig.29).
4) Grip the handle by pressing the throttle trigger
lock out (fig. 30) with the palm of your hand, thus
24
Fig.26
Fig.28
1:25 (4%)
Fig.30
Fig.32
Fig.34
allowing you to move throttle control lever (fig.30
item 1) freely.
5) Press the throttle control lever right down (fig.31).
6) Hold the levers (fig.31) down and push the throttle
lock button (fig.32) right down.
7) Hold the button down and release the throttle
ON
Fig.27
OFF
Fig.29
Fig.31
1
Fig.33
Fig.35
2
ON
OFF
1