Publicité
STEP 3
Attach the push handle to the vertical posts of
the main frame assembly using one M6x40
round-head bolt, one eyebolt, two M6 flat
washers and two M6 lock nuts, as shown.
STEP 4
Line up the drum assembly inside the main
frame assembly. Attach the crank handle
through the mount so that it supports one end
of the drum assembly using one M6x40 round-
head bolt, M6 flat washer and M6 lock nut.
While holding this in place, attach the hose
coupler mount to the main frame assembly on
the other end of the drum assembly using two
M6x40 round-head bolts, two M6 flat washers,
and two M6 lock nuts, as shown.
STEP 5
Insert one of the rubber washers into the
female swivel coupling on the drum assembly.
Connect the male end of the leader hose.
Insert the second rubber washer into the
female end of the flexible hose. Attach the gar-
den hose to the threaded water supply tube,
and wind onto the reel.
Publicité
