LEAD energy SSW20 Manuel D'utilisation page 6

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
You can attach the LED STRIP products to walls or ceilings to generate continuous bar lighting.
Note
Please observe the warnings prior to installation.
Connect to the power supply in accordance with national regulations. The light source of this luminaire is not
replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. The luminaire
contains no replaceable parts. In the case of a fault, the complete luminaire must be disposed of. Retain the
operating instructions for later use.
WiFi control must be accessible for configuration of your product.
Note that the protection class refers only to your LED STRIP product. You must protect the wiring, the power
supply and the WiFi dimmer from moisture.
1.000 mm 1.200 mm
Danger
Always only operate LED STRIP products in an unwound
state. Operating an LED STRIP product in a wound state
may lead to irreparable damage.
"Hereby, LEAD energy AG, declares that this type of equipment is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC."
https://www.lead-energy.com/dynamic-control
LEAD ENERGY AG Zollhof 30 40221 Düsseldorf
IP 20
WiFi
150 mm 150 mm
Subject to errors and amendments
?
300 mm 250 mm
Information / Technical support: www.lead-energy.com
service@lead-energy.com
www.lead-energy.com
IP 20 - 70200038, 70200042,
70200046, 70200050
IP 68 - 70200039, 70200043,
70200047, 70200051
5.000 mm