Applications; Remote Control - Monacor FM-102DAB Mode D'emploi

1
6
POWER
Digital Stereo Tuner for the
Reception of DAB+ and FM
These instructions are intended for users
without any specific technical knowledge .
Please read these instructions carefully prior to
operation and keep them for later reference .

1 Applications

The FM-102DAB is used to receive FM
stations and the "digital radio" DAB+
(Digital Audio Broadcasting) in the band III
(174 .928 – 239 .200 MHz) . For storing sta-
tions, 20 station numbers each are available
for FM and DAB reception .
2 Safety Notes
The unit corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to
skilled personnel only . Inex-
pert handling or modification
of the unit may result in electric
shock .
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water and splash
water, high air humidity and heat (admissi-
ble ambient temperature range: 0 – 40 °C) .
•
Do not place any vessel filled with liquid on
the unit, e . g . a drinking glass .
•
Do not operate the unit and immediately
disconnect the mains plug from the mains
socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket, always
seize the plug .
8
2 3 4 5 SHIFT
7 8 9 10 MUTE
ANTENNA
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no
liability for any resulting personal damage
or material damage will be accepted if the
unit is used for other purposes than origi-
nally intended, if it not correctly connected
or operated or if it is not repaired in an
expert way .
3 Setting Up and
.
Connecting the Unit
The unit can be installed in a rack (482 mm /
19") by means of its mounting brackets,
but may also be used as a desktop unit .
For installation in a rack, one rack space
(RS = 44 .45 mm) is re quired .
Prior to making or changing any connec-
tions, switch off the tuner and the unit to be
connected .
1) Connect the RCA jacks LINE OUTPUT
located on the rear side of the unit to the
line signal input of an audio unit (amplifier,
active speaker system, mixer, audio matrix
router, etc .) .
2) On the rear side of the unit, the jack
ANTENNA is available for antenna connec-
tion . The telescopic antenna provided can
be connected to this jack and fastened .
To obtain optimal reception of weak
stations, align the antenna by means of
the signal strength indication . To activate
the signal strength indication, press the
button INFO repeatedly until a bar graph
appears on the lowest display line .
3) For power supply, connect the mains jack
to a mains socket (230 V/ 50 Hz) using the
mains cable provided .
104.80MHz St FM
19:23 25-01-2018
LINE OUTPUT
R L
If the unit is to be put out of oper-
ation definitively, take it to a local
recycling plant for a disposal which
is not harmful to the environment .
IR
FM-102DAB
MODE MENU INFO SLEEP
DOWN UP ENTER FM LIST
230 V~ /
50 Hz
FUSE
4 Operation

4.1 Remote control

1) To insert the batteries (2 × 1 .5 V, size AAA),
remove the battery compartment cover on
the rear side of the remote control . Insert
the batteries as indicated in the battery
compartment . Close the battery compart-
ment with the cover .
If the remote control is not to be used
for a longer period of time, remove the
batteries to prevent any damage due to
battery leakage .
2) When pressing a button, point the remote
control at the sensor "IR" . Make sure that
there are no obstacles between the remote
control and the sensor .
3) If the range of the remote control de-
creases, the batteries are discharged and
must be replaced .
Discharged batteries must not be
placed in the household waste; al-
ways take them to a special waste
disposal, e . g . collection container at
your retailer .
4.2 Tuner
1) Switch on the unit with the POWER switch .
/
Welcome! Digital Radio
appear on the display; then the station
most recently selected will be indicated .
2) The operation options are listed in the
table to the right . Some settings can al-
ternatively also be made via a menu . Other
settings can only be made via the menu .
Please refer to pages 10 and 11 for the
menu structure . To call up the menu, press
the button MENU . All the other steps are
given in the figure .
The display will return from some menu
items to the indication of the station set
if none of the buttons MENU, DOWN, UP
or ENTER is pressed within a time period
of approx . 5 seconds .
3) During initial operation, first store the sta-
tions that can be received at where you
are located . 20 station numbers each are
available for FM and DAB+ reception .
TUNE
ENTER
AUTOSCAN
will be