MESTIC MA-100 Mode D'emploi page 9

Using your fryer
Before using the fryer for the first time:
• Remove all packaging material.
• Wash all the fryer accessories with mild dish detergent rinse thoroughly with clean water.
• Dry all accessories thoroughly and reassemble in the fryer.
Preparing for use
• Place the appliance on a stable, horizontal and level surface.
• Place the basket in the pan.
• Put the mains plug in an earthed wall socket.
Preheating
You can preheat the device without any ingredients. In this case, turn the timer button to more than 3 minutes and wait till the time has
expired. Then fill the basket with ingredients and turn the timer knob to the required cooking time
Hot air frying
• Remove the basket carefully from the device.
• Put the ingredients in the baskets.
• Slide the drawer back into the fryer by handle.
• Determine the required cooking time and required temperature for the ingredients by turning the timer and temperature knob.
• When you hear the timer bell, the set time has elapsed. Open the drawer by pulling the handle and make sure the food items are
ready.
• To remove the ingredients, lift the basket out of the pan by handle.
• Empty the basket into a bowl or onto a plate.
Maintenance
• It is important that you clean the entire appliance after each use to prevent an accumulation of grease and avoid unpleasant odours.
• Allow the appliance to cool and unplug form outlet before cleaning.
• Do not immerse appliance in water or wash it under running water.
• If the surface of basket and bottom have non-removable oil-dirty, please use damp sponge with abluent to swab down it after
immersed basket and bottom into the water about 10 minutes. Wipe up the basket and bottom before you store them.
• Using a damp sponge with abluent to clean the interior of fryer , then wipe up it with dry cloth
• Do not use abrasive cleaners or sharp utensils to clean the fryer, as it will scratch the fryer body.
• Let all parts and surface dry thoroughly prior to starting or operating the fryer again.
Warranty does not cover
• If the above points have not been observed.
• If the appliance has not been properly maintained, if force has been used against it, or if it has been damaged in any other way.
• Errors or faults owing to defects in the distribution system.
• If the appliance has been repaired or modified or changed in any way or by any person not properly authorized.
• Do not repair the power cord by yourself or don't use the product any more in case the power cord is damaged, and please contact
the appointed Service Agent or Centre immediately.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this
product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or dismantled to
minimize its impact on the environment. For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and
human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MA-100, applies all basic requirements and other relevant regulations listed
in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive (2014/35/EU). If you require a full
declaration of conformity, you can contact the adress listed on the backside of this manual
ENGLISH