Items Included; Setup Procedure - Max ERZ-300 Mode D'emploi

2. Items included

Main unit

3. Setup procedure

①
Pull out the waste box.
②
Insert the power adapter DC plug (and foot switch plug) into the
jack on the electric staple remover.
③
Insert the power adapter AC plug into the wall socket.
● CAUTION: Set up on a stable flat surface.
● CAUTION: Set up in a manner where the machine is not placed on
the adapter and power cord wires.
● CAUTION: Place the power cord (and foot switch cord) in a location
where it will not be tripped on.
● CAUTION: When moving the machine, be sure to dispose of the
staples before moving.
④
Insert the waste box. Preparation for removal is complete when
the LED on the top is illuminated.
IMPORTANT:
Please follow the following cautions when using a foot switch.
● For the foot switch, use a product with a 3.5mm jack.
● To use a foot switch with a 6.35mm jack, use a converter cable to convert it to 3.5mm.
● Both normally open and closed foot switches can be used.
● Connect the foot switch after disposing of staples remaining in the waste box.
● When using the foot switch, insert the power adapter AC plug into the wall socket
after inserting the foot switch plug.
4. Procedure for using electric staple remover
①
Insert paper into the remover with the staple legs facing upward.
● ATTENTION: Do not insert stapled sheets other than paper. Doing so may lead to machine malfunction.
②
Align the staples with the staple position LED.
● NOTE: Work sitting down so the LED can be seen.
● IMPORTANT: Misaligning laterally from the staple alignment position may result in failed removal and damage
to the paper.
③
Press the button (or step on the foot switch) while holding down the paper.
● IMPORTANT: Staples other than those in the specifications may not be properly removed.
● IMPORTANT: Dispose of accumulated waste staples daily after work is complete.
● CAUTION: Do not touch bent staples or staples remaining in paper bundles with bare hands. Doing so may
lead to injury.
● IMPORTANT: Depending on the binding position or condition of the staples or paper, staples may not be
removable or the paper or staples may be damaged.
①
power adapter
②
3
power cord
This cord is for EU model.
The plug is different
depends on each model.
Please obtain a commercially available foot
switch if needed.
instruction
manual
①
②
③
④
③