Harmopool CLEVER-POOL ENERGY SAVER Instructions D'installation Et D'entretien page 5

4. buttons can be used for speed changing, pressing
each time, 50RPM decrease. After setting, pressing
"PUMP ON", pump starts to work.
5. When LCD screen shows "PUMP OFF", pressing
working mode changes from"MANUAL MODE" to"AUTO MODE", setting at first time starts from"CURRENT
TIME", then set one by one the "START TIME", "STOP TIME", "0000(speed)" of timing period 1,2,3,4. Pressing
or to increase or decrease, press
are "00:00", it is recognised as null.
6. Only when pump stops, parameter setting is available, press
7. When pump running under "AUTO MODE", press
8. When parameter setting, if no operation over 5 seconds, CLEVER-pool jumps to home page.
9. Hold the button for over 5 seconds, you can re-set the system or erase all setted parameter.
10. If "CURRENT TIME" needs to be re-setted, you need to re-set the system.
4. BUTTON AND FUNCTION EXPLANATION
1
11
10
9 8 7 6 5
Dial- Frequency
Switch option
S1
Motor rotation
direction
each time, 50RPM increase, pressing
, status changes from"PUMP OFF" to
to set parameters. Double press
for confirmation. When setting, if "START TIME" and"STOP TIME"
to change pump status.
and system jumps to"MANUAL MODE".
NR. NAME
1 Power light
2 Pump light
3 Increase
2
4 Decrease
3
5 Full RPM
4
6 High RPM
7 Medium RPM
8 LOW RPM
9 LCD screen
10 Setting
11 Run/Stop
"N" stands for 50Hz
"2" stands for 60Hz
If three-phase motor runs in anti-clockwise direction, move
"O" to"1" (not valid for this model CLEVER-pool)
,
EXPLANATION
Power supply connected or disconnected
Pump on or off
Increase the parameter
Decrease the parameter
Pump motor RPM setting
Pump motor RPM setting
Pump motor RPM setting
Pump motor RPM setting
Showing all parameters
Parameter setting or re-set system
Manually control pump run or stop