Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OP-10STX | Manuel d'installation et d'utilisation | Installation and user manual |
c. Press the button SET to confirm. The
light next to the channel indication starts flash-
ing rapidly before it stops flashing.
5. Volume controls for the input channels CH 1
and CH 2.
6. 3.5 mm jack to connect stereo headphones
(impedance ≥ 16 Ω).
7. Combined monitor selector and volume con-
trol for the headphone output (6) Press to
switch between the transmission signal.
(mixed signal CH 1 / CH 2) and the input signal
of channel CH 3. The corresponding LED of the
indication "Monitor" (c) lights up. Turn to adjust
the volume.
8. Unbalanced 6.3 mm jack to connect a mono
audio source to the input channel CH 3 (e. g.
connection to the line output of the control
panel of a conference system); the signal of this
input will not be transmitted but only repro-
duced via the headphone output (6)
9. Switch to activate a phantom power –/-
(approx. 46V ) for the input CH 1 IN (12) caution
note in chapter 4
10. Power supply jack to connect the power
supply unit provided.
11. Feed-through outputs via 6.35 mm jacks to
route the input signals of the jacks CH 1 IN and
CH 2 IN (12) to inputs of another audio unit (e.
g.amplifier, additional transmitter).
12. Balanced combined XLR / 6.3 mm jacks to
connect up to two mono audio sources (e. g.
desk microphone, mono line output of an audio
unit) or a stereo audio source (e. g. master out-
put ofa mixer) to the input channels CH 1 and
CH 2.
13. BNC jack for the antenna (1) provided.
20
Publicité
Table des Matières
