CTC MRC 7007 Mode D'emploi page 38

To set the second alarm time, repeat the above steps with the AL2 / VOL+ button.
NOTE:
• In case of an activated alarm time, a dot will light up at "AL 1 BUZZER /
AL 1 RADIO" and/or at "AL 2 BUZZER / AL 2 RADIO".
• The alarm function ends automatically after approx. 60 minutes and the device
switches off.
Turning Off the Alarm
To shut the alarm signal off until the next day, press the ON / OFF button.
Automatic Alarm Interval
The automatically set alarm function can be shut off for approximately 9 minutes with
the DIMMER / HIGH / LOW / SLEEP / SNOOZE button.
NOTE:
If the function is activated, the dot next to "AL 1 BUZZER / AL 1 RADIO" and / or at
"AL 2 BUZZER / AL 2 RADIO" will flash.
Deactivate the Alarm Function
1. Switch the device off.
2. Press AL1 / VOL− or AL2 / VOL+ until the dot at "AL 1 BUZZER / AL 1 RADIO" or at
"AL 2 BUZZER / AL 2 RADIO" goes out.
CAUTION:
Do not immerse the device in water.
• Disconnect the mains plug before cleaning.
• Clean the device with a soft damp cloth without detergents.
Problem Cause
The device can- The device is
not be operated. blocked and
"hangs".
38
MRC7007_CTC_IM
Cleaning
Troubleshooting
Solution
Disconnect the power supply for 5 sec-
onds. Then switch the device on again.
12.10.17