Nowsonic AUTARK DS512 Mode D'emploi page 7

www.nowsonic.com
Outlets on the rear panel
The following outlets are available on the back panel of the Autark
:
DS512
3 4
1
2
1. POWERCON IN / POWERCON OUT
Connect the included power
IN
socket. To do this, insert the power
turn it clockwise until it locks into place: now, the plug is firmly at-
tached to the device and cannot be accidentally removed. In order
to unplug the plug, pull the spring-mounted catch back and turn the
plug counterclockwise.
NOTE:
power CON
incorrect connections. This makes it also impossible to acciden-
tally connect speaker plugs, which are similar in design.
You can daisy-chain the applied power supply to subsequent devices
via the POWERCON OUT
5
2. socket
DC 12V IN
You can connect an optional 12 V
IN socket. The assignment is printed below the socket and is as
PIN
follows:
Assignment
Pin 1: negative phase
Pin 2: not used
Pin 3: not used
Pin 4: positive phase, +12V
7
Nowsonic Autark DS512
User manual
power cord with the
CON
plug into the socket and
CON
sockets offer mechanical protection against
socket.
power supply via the
AC
GB
POWERCON
DC 12V