Selecting The Temperature - SOLAC CT8630 Mode D'emploi

SELECTING THE TEMPERATURE

• To change the temperature selection, press the temperature button (4.6);
you can increase the temperature position by pressing the selection increase
button (4.8). If a position higher than 1 is selected, you can reduce the
temperature position by pressing the selection reduction button (4.9).
• To confirm your selection, press the temperature button again (4.6) or else
it confirms automatically after a few seconds. The temperature that corre-
sponds to the selected temperature position appears on the screen when
you confirm the selection (4.2).
• There are 4 temperature positions that correspond to the following tem-
peratures:
Position 1: 30ºC
Position 2: 35ºC
Position 3: 40ºC
Position 4: 45ºC
• The selected temperature will be reached after 10 minutes and it will remain
stable after this time regardless of how long the appliance is left running.
SELECTING THE OPERATING TIME
• When the appliance is switched on, the time selected by default before the
product switches off is 120 minutes. It is possible to reduce this time by
pressing the timer button (4.7) and then pressing the selection reduction
button (4.9). If a time of less than 120 min. is selected, you can use the
selection increase button (4.8) to increase the time before the appliance
switches off automatically.
• From 10 to 50 minutes, these buttons allow you to increase/reduce the time
by five minutes every time they are pressed. After 50 minutes these buttons
change the time by 10 minutes.
• To confirm your selection, press the timer button again (4.7) or else it confirms
automatically once a few seconds have passed since your last selection.
• When you confirm the selection, the selected time appears on the screen
(4.5) and the time starts to count down one minute at a time; this also ap-
pears on the screen (4.4).
• Once the selected time has passed, the appliance stops heating up, the
screen shows the FF symbol and the light on the control flashes until any
button is pressed.
• If any operating error is detected or the power cord is not properly con-
nected to the product, the screen shows the ER symbol and the light
flashes. Make sure the cord is properly connected, switch off the control and
switch it back on.
• The light of the screen is blue; it comes on while the control is being used
and switches off automatically after 5 seconds. If you want it to light up
again, press the selection increase button 4.8 or the selection reduction
button 4.9.
CT8630-8635-8650 11
11
10/10/06, 10:18:17