Technical Data; Cleaning And Maintenance - MSW -STAPLER 1500 Manuel D'utilisation

10. ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other liquids.
11. Under no circumstances should the housing be opened.
12. Do not touch the hot connecting element – danger of burning.
13. Do not use the device in the vicinity of flammable materials.
14. Do not use the device in explosion hazard zones.

3. TECHNICAL DATA

Product name
Model
Nominal power supply [V] / Frequency [Hz]
Rated power [W]
Maximum temperature of welding staples [°C]
Weight [kg]
4. SCOPE OF THE APPLICATION
The plastic fusing machine is designated for repairing plastic elements by fusing welding staples of different
shapes.
The user is liable for any damage resulting from non-intended use of the device!
5. BERORE THE FIRST USE
Upon receipt of the goods, check the packaging for defects and open the packaging if there are no damages.
If the packaging is damaged, please contact your transport company and distributor within 3 days, and
document the damages as detailed as possible. Do not turn the package upside down! When transporting
the package, please ensure that it is kept horizontal and stable.
6. DISPOSING OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic tapes and Styrofoam), so that in case of a problem, the
device can be sent back to the service centre in accurate condition!
7. INSTALLING THE APPLIANCE
POSITIONING THE DEVICE
When in use, hold the device firmly and securely in your hands. When in use, ensure unobstructed access
to the electricity plug at all times. Make sure the power source reflects the parameters on the rating plate!
8. MACHINE OPERATION – BASICS
Device operation
Before connecting the device to an electricity supply, attach
welding staple guides to the gun.
8
Hot Stapler
MSW-STAPLER 1500
230~ / 50
100
~620
7
Rev. 31.05.2017
Then connect the device to an electricity supply and set the
switch in the rear of the housing to "ON".
Once the device is on, select the required power. Numbers on
the display represent the percentage of the power used to heat
up the welding staple. Use "-" (reduce power) and "+" (increase
power) buttons to set the power.
Use buttons 1-4 for faster settings.
Once the required power has been set, insert a welding staple
into the guide. Press the trigger to heat up the welding staple.
Once the staple has been heated up to the correct temperature
you can begin bonding. Welding staples in different sizes are
included. Select an appropriate welding staple shape for the
bonded element.
9. TRANSPORTATION AND STORAGE
During transport, the machine should be protected from shaking, crashing and turning upside down. Store it
in a properly ventilated place with dry air and without any corrosive gas.

10. CLEANING AND MAINTENANCE

• Disconnect the machine from the electricity when cleaning it.
• Use cleaner without corrosive substances to clean surface.
• After cleaning, all parts should be able to dry before the machine is to be reused
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
• Never spray the device with water jets.
11. CHECK REGULARLY THE DEVICE
Check regularly that the device doesn ́ t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 31.05.2017
9