Classic Accessories OVER DRIVE SkyShield Mode D'emploi page 3

Instructions SkyShield
Your cover is equipped with extra long
zipper pulls. To secure the zipper pulls so
that they do not drag on the ground bring
the ends of the zipper pulls up and tuck
them into the rip-and-grip closure located
at the base of the zipper along the hem
(Fig. 9).
Use and Storage
To store your cover roll your cover up back
to front. Put your rolled up cover into the
storage bag. Pull draw string tight. Place
the top of the storage bag back on the bag
making sure the straps are not twisted.
Working around the bag tighten the straps
down to desired size.
Note: For easier packing and re-installing
fold and roll tightly before packing in
storage bag.
Never store a wet cover in the storage
bag or confined area as the cover can be
damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don't use abrasive cleaners
or brushes.
Included with the cover is a roll of
adhesive backed fabric. This can be used
either as a reinforcement or to fix a tear.
Reinforcement: If you notice any sharp
edges during installation cut a piece of
patch fabric and adhere it to the inside of
the cover corresponding to the location
of the sharp edge (i.e. antennas, drain
spouts). Apply pressure to thoroughly
adhere patch.
Fix a tear: Cut a piece of patch fabric to
generously cover the area of the tear. On
the inside of the cover, clean the area
around the tear with water and mild soap.
16cR51_19318
™
Peel off the backing on the patch and stick
over the tear on the inside of the cover.
Apply pressure to thoroughly adhere
patch.
Do not attempt to repair or add
reinforcement if cover is wet.
HINT: Round the corners when cutting the
patch for better adhesion.
CLASSIC ACCESSORIES, INC.
KENT, WA 98032 USA ©2016
c l a s s i c a c c e s s o r i e s . c o m
Fig. 7
Fig. 8
Fig. 9
do not line dry
use soap
do not iron water
resistant
do not
pack wet