Installing The Tubular Motor - WR RTBS Série Notice D'utilisation Et De Montage

Installing the tubular motor

NOTE
The following installation instruction apply to standard installation
situations for Rademacher tubular motors and accessories.
The drive head (12) of the motor can be installed on the right or left
side of the roller blind box. Installation on the right side is shown in
these instructions.
Installing the bearings (Figure
1. First, determine the position of the drive (13) and counter
bearings (1) in the roller shutter curtain.
Wind the roller blind shield completely onto the winding shaft, and
measure the diameter D. See Figure
of the centre of the bearing on the guide track.
IMPORTANT
When installed, the wound-up roller blind must run vertically in the
guide track on the window.
Determine the length of the winding shaft (Figure
1.
Measure the distance from the drive (13) to the counter bearing (1),
as shown.
B
Assembly / disassembly of adapters and driver (Figure
1. Assembling the adapter (10)
Slide the adapter (10) over the limit ring (18) on the drive head
until it engages. Make sure the groove in the adapter (10) is
correctly positioned.
2. Disassembling the adapter (10)
Press down on both retaining springs on the limit ring (18) and
pull the adapter (10) off of the limit ring (18).
36
D ES F
for determining the position
2
L
A
GB NL
)
2
2. Mount the bearing, depending on the type of bearing and the
building situation.
Assemble the drive bearing (13) such that the adjustment screws (11)
will be accessible later, and the motor cable can be run without
kinking.
Take care that the bearings are level when installed. A roller blind that
is crooked when wound up can jam and destroy the drive.
2.
Measure the roller blind box and determine the shaft length (L)
needed.
Length of the winding shaft:
3. Cut off the winding shaft (5) to the required dimension.
Saw off the shaft squarely with a metal saw to the correct dimension.
Deburr the shaft, inside and outside, with a file.
C
B = Counter bearing / Roller capsule
C = Drive bearing / Motor
1. Assembling the driver (8)
Slide the driver (8) onto the axle (19) to the stop and secure it with
the included securing clip (7).
2. Disassembling the driver (8)
Remove the securing clip (7) from the axle (19) and disassemble
the driver (8).
)
3
L = A - (B + C)
4 )
GB