Intelligent GFM201 Manuel D'installation Et D'utilisation page 12

Assembly
Connection to the power grid will be preferably through the rear plug.
In order to assemble the hand dryer complete the following steps:

Make four drill holes with an 8 mm (0,31") diameter in the wall, using the provided
template (Figure 4).

Clean the dust away from the holes and insert the wall plugs.

Pass the electrical cables from the power grid through the hole with the 22 mm (0,87")
diameter which is situated above the device's terminal strip (Figure 5).
Figure 4.

Firmly screw the base of the device to the wall (Figure 6), ensuring that the 4 silent-
blocks are correctly placed between the base and the wall.

Connect the electrical cables to the hand dryer's terminal strip. Connect the cables
corresponding to the two phases (N and L) and to earth in the corresponding sockets of
the terminal strip, as indicated by the engraved letters (Figure 7).
Figure 7.
Figure 8.
https://www.intelligenthanddryers.com/
Figure 5.

When making these
disconnecting from the power grid with a minimum contact
separation of at least 3 mm (0,12") for all poles. These
disconnection means must be incorporated into the fixed
installation.

The hand dryer must be installed against a solid surface only (wall,
partition, or similar).

Carefully place the casing on the base of the device. To do so
place it over the base with a slight incline from top to bottom, in
such a way that the tab in the casing correctly inserts into the
corresponding slot in the base (Figures 8 and nº 9).

Place the screws for fixing the casing to the base, fixing them
tightly using the special spanner provided (Figure 10).
Figure 9.
Figure 6.
connections contemplate
Figure 10.
means for