Publicité
ALFA PLUS / URB. Y / REFLEX / NEW DAY
/ VINTAGE / ADVANCE / LOOK
www.sanindusa.pt
CISTERNS WITH MECHANISM INSTALLED
Information on assembly /
Installation of cisterns Sanindusa.
This cistern, with the mechanism already installed, needs no
further assembly operations, besides direct application to
toilet suite.
The cistern is supplied with adequate screwing, both in the
fixation screws and the water entrance tap and mechanism.
We do not advise readjustments of these pieces, prior to
installation.
The regulation of the water level in the cistern is already set,
so that cleanness and flushing can be adequate. However, it
may be considered necessary to make some adjustments,
suitable to water pressure where the cistern is installed.
Install, between the toilet suite and the cistern, the sealing
rubber, which is supplied the cistern, and fix it to the toilet
suite, using the wing nuts and the spring washers.
In case you notice any water leaks, after installation, rescrew
the pieces, where the leak was discovered.
Never use silicone or other sealing products, as they were
considered to be unnecessary and damaging to sealing
rubbers.
In case there are technical problems, you may contact our
technical department.
Telephone: +351 234 940 250
We thank you for your cooperation and advise you to thoroughly follow
all the assembly instructions in order to obtain adequate results.
Publicité
