Switching The Appliance On; Operating Tips; Setting The Temperature - Blaupunkt 5FG2 Série Mode D'emploi

Controls
Fig. "
1
Temperature controller
Is used to set the freezer
compartment temperature.
2
On/Off button
Serves to switch the whole
appliance on and off.
3
"super" button
Switches super freezing on and
off.
Illuminates when super freezing is
on.
4
Alarm button
Used to switch off the warning
signal, see chapter "Alarm
function".
5
Alarm display
Lights up if the freezer
compartment becomes too warm.
It goes out when the freezer
compartment has reached the set
temperature.
Switching
the appliance on
Fig. "
Press the On/Off button 2, the button is
lit. The temperature alarm is switched off
by pressing the alarm button 4. The
alarm display 5 lights up until
the appliance has reached the set
temperatures.
We recommend the medium setting.

Operating tips

The sides of the housing are
■
sometimes heated slightly. This
prevents condensation in the area of
the door seal.
If the freezer compartment door
■
cannot be immediately re-opened after
it has been closed, wait until the
resulting low pressure has equalised.
The refrigeration system may cause
■
several areas of the freezer shelves to
frost quickly. This does not affect
function or power consumption. The
appliance does not require defrosting
until the entire surface of the freezer
shelf is covered with more than 5 mm
of frost or ice.
Setting
the temperature
Fig. "
Set the temperature controller 1 to
a number with a coin. The higher
the number, the lower the temperature.
en
23