Operating Your Stand Mixer - KENMORE ELITE KKESM600M Guide D'utilisation Et D'entretien

PREPARING TO USE YOUR STAND MIXER
BEFORE FIRST USE
1. Before using your Bowl Lift Stand Mixer, remove all packing material, plastic, labels, stickers or
tags that may be attached to the Mixer, Bowls or Attachments.
2. Before the rst use of the Stand Mixer, wash the white Flat Beater, white Dough Hook, and
Stainless Steel Bowls in warm, sudsy water or in the dishwasher. The Wire Whip should be washed
by hand only. Rinse and Dry all thoroughly.
3. The exterior of the Stand Mixer should only be cleaned with a soft damp cloth, then dried.
4. Place Bowl Lift Stand Mixer on a dry, level, stable, surface such as a countertop or table. Keep
Mixer away from countertop edge. Be sure to leave plenty of room around Air Vents at the rear of
Mixer.
NOTE
Do not use abrasive cleansers or scouring pads when cleaning your Bowl Lift Stand
Mixer, NEVER immerse the body of the Stand Mixerin water or any liquid.

OPERATING YOUR STAND MIXER

TO ATTACH BOWLS TO MIXER
1. Turn Speed Control Knob to OFE
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position (Fig. 2).
4. Fit the Bowl Supports over Locating Pins (Fig. 3).
NOTE : For both Bowls, t the Detent Ball on the back of the Bowl into the Detent for it on the
Mixer. (Fig. 4).
5. Raise the Bowl Lift Handle up into the Locked position ( g. 5).
CAUTION
Never turn on Mixer with Beater, etc. attached unless the Bowl is in place.
Failure to heed this advice could result in broken bones, cuts or bruises.
4
OPERATING YOUR STAND MIXER
TO ATTACH FLAT BEATER, WIRE WHIP OR DOUGH HOOK
1. Turn Speed Control Knob to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position.
4. Align slot at the top of Beater/Attachment with pin on Mixer
Head's shaft. Push Beater /Attachment up onto shaft and turn
counterclockwise until pin moves all the way into the slot (see
Fig. 6 and 6A).
5. Before using Mixer, be sure to place Bowl Lift Handle in the up
position.
TO REMOVE FLAT BEATER, WIRE WHIP OR DOUGH HOOK
1. Turn Speed Control Knob to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position.
4. Turn Beater/Attachment clockwise on shaft until pin, on shaft
lines up with slot on attachment. Pull down and o .
TO REMOVE BOWLS FROM MIXER
1. Turn Speed Control Knob to OFF.
2. Unplug Stand Mixer or disconnect power.
3. Place Bowl Lift Handle in down position.
4, Pull up on Bowl Supports and lift Bowl o of Locating Pins.
5. Remove Bowl.
TO ATTACH SPLASH GUARD
Another feature of this Mixer is the Splash, Guard, which
helps keep ingredients from splashing out of the bowl while
Mixer is on. The Guard ts over the rim of either Bowl. The
Splash Guard also has a funnel area for adding ingredients
while the Mixer is on.
Attach Splash Guard after Bowl and Beater, Whip or Hook
have been attached. The open part of the Splash Guard faces
the Mixer, with the funnel on the right as you face the Mixer
(Fig. 7). Rest the Splash Guard on the rim of the Bowl with the
plastic tabs on the outside of the Bowl (Fig. 7A).
5