Water Level - Haier QPHR50 Manuel D'utilisation Et Instructions D'installation

USING THE DEHUMIDIFIER
Removing Collected Water (cont)
To Install Hose: Push in hose and gently pull to make sure it is
secure. Should not be able to be removed. You should hear a
"click" that lets you know the hose is inserted correctly.
To Release Hose: Press the blue button on top of the connector
attached to the dehumidifier and pull the hose out to remove. Be
sure to turn off the pump before removing the hose.

Water Level

The dehumidifier will turn off automatically when the bucket
is full, or when the bucket is removed or not replaced in the
proper position.
Bucket Operation
DO NOT remove the foam piece and magnet block in
the bucket assembly. If removed, the Dehumidifier will
not work properly.
When the coil is defrosted, the compressor or fan will
automatically restart and dehumidifying will resume.
8
Insert
Press
Pull
NOTE: DO NOT kink or crimp hose, as it can block water flow.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the dehumidifier
will not run if the bucket is not in the proper position.
49-5000429 Rev. 5