Acksys WLg-IDA/S Guide D'utilisation Rapide page 22

11 status LED display the state of the product::
LED
Power 1
Power 2
Diag(*)
C-Key Orange /
WLan(*)
Bargraph
Serial
Tx/Rx
RS422/485
(*) Diag + Wlan Tx/Rx: alternative blink
This blink is meaningful only in infrastructure topology. It means that the
product did not yet associate with an access point, or WPA keys are wrong.
If it is not possible to shutdown the
power supply,
accessible by a hole located just
before the supply connector allows
resetting the product. You can use, for
example, a paper clip to press the
button. The press must be brief: if it
takes more than two seconds, the
product will reset to factory settings.
DISPLAY LEDs
Color
This led is ON when the power supply connector is
Green correctly powered using the "PWR1" and the
"GND1" pins of the power supply connector.
This led is ON when the power supply connector is
Green correctly powered using the "PWR2" and the
"GND2" pins of the power supply connector.
After power up this led stays on until the product is
operational (less than 10s).
If the led stays on steadily more than 30 seconds at
power up, the product is out of order.
Red
After boot-up it indicates either special states
depending on the active service, or reception errors
on the serial port.
In serial port administration mode, this led blinks
twice per second, indefinitely.
Off:
Bicolor
Orange:
Green:
green
Blinking:
Blue Flashing according to WLAN Tx/Rx activity.
The four bars show the receive level of the Wi-Fi
Green
interface.
Flashing according to serial Tx/Rx activity.
Green
This led is ON when you use a differential (RS422
Green
or RS485) electrical interface.
a micro-switch
Description
no C-Key is detected.
the C-Key data is invalid or corrupted.
the C-Key data is valid.
during reads and writes to the C-Key.
RESET
-10-