Install Battery - Amplicomms SA-40 Mode D'emploi

Install battery

1 Install battery as shown.
2. Charge before use. Allow approximately 3-4 hours
for the charging process.
Charging
1 When your SA-40's battery charge is low, the Bat-
tery Indicator will will continuously flash.
2. To charge the SA-40, connect AC Adapter as
shown. Typical charging to full charge is 3-4
hours. While the SA-40 is charging, the Battery
Indicator Light will be steadily lit.
4. When the the SA-40 is fully charged, the Battery
Indicator Light will go out.
5. The SA-40 should never be connected to the AC
Power Adapter for more than one week.
G
ETTING STARTED
19