Princess HEALTHY TURBO BLENDER Mode D'emploi page 5

USE
General
Note: do not add hot liquids or ingredients into the Healthy Turbo
Blender.
• Chop all your ingredients into approximately 2-3cm cubes and add to
the Healthy Turbo Blender, make sure you keep the ingredients under
the MAX mark on the jar.
• Any ingredients to be added during the process can be added through
the refill hole in the center of the lid. Do not unlock or remove the lid as
this will stop the program.
• Any interruption will result in the cancellation of the program. Restarting
will result in the blending stages being repeated which may affect the
final recipe.
• To completely stop the program at any time, simply press the on/off
button.
Manual operation setting
• When the jar and the lid are installed properly (refer to paragraph "before
the first use") you can turn on the Healthy Turbo Blender. The display
will light up, the default speed setting is "3" and the default time setting
is 00.40 minutes.
• Use the time buttons to increase(+) or decrease(-) the time setting and
use the speed buttons to increase(+) or decrease(-) the speed setting
(don't use low speed for blending dense food.)
• Press the on/off button to start the blending process. During use the
speed and the time setting can be adjusted.
• To interrupt the process you can use the on/off button.
Pulse button
Use the PULSE button to blend for short times, press and keep the PULSE
button to blend, release the button to stop.
Preset programs
• When the jar and the lid are installed properly (refer to paragraph "before
the first use") you can turn on the Healthy Turbo Blender.
• Now you can choose between 6 different preset blending programs
(Ice, Fruits, Grinding, Soup, Smoothie and Sauce.)
• After you have selected a program, the picture off the selected program
on the display will illuminate, the start speed and remaining time will be
displayed.
• Press the on/off button to start the selected program, press the on/off
button again to interrupt the running program. Note that the complete
blender will turn off when you interrupt the program, after interrupting
you can not continue the program at the point you have interrupt it.
EN
5