InnoEssentials silk'n DualClean Instructions D'utilisation page 4

III + IV Micro-Fiber bristle brush applicators – Attach and remove
To attach a brush head, place the center of the brush head on the matching attachment point located on
the device. Press the center of the brush head and push down until it snaps into place. To remove the
brush head, simply grip the outer plastic base of the brush head firmly in one hand and the device handle
in the other hand and pull up evenly until it snaps loose.
When using the Cotton pad brush, first attach the cotton pad brush to the device and then attach a clean,
new cotton pad to the velcro side of the brush. You can use the cotton pad brush with your favourite cotton
pads*. The cotton pads you choose to use should be at least 5cm and at most 6.5cm diameter for optimal
performance. Now you can use it the same way you would use a bristle brush head. Using cotton pads that
are too small can result in the velcro contacting the skin during use, which can cause damage to your skin.
Using DualClean facial brush
Use daily to remove the epidermal (outer) layer of dry and flaky skin cells. With it's 2 speed settings you
have the freedom to choose a speed that suits your skin.
1. Press On/Off button once - low-speed function
2. Press On/Off button twice - hi-speed function
3. Press On/Off button three times - device turned off
For use separately
Dampen your face with warm water. Press firmly to the area you want to treat, select mode and move the
DualClean in an upward, circular motion. Recommended treatment time per area is 30 seconds for each
area - forehead, nose, chin and each cheek. The micro-fiber bristle brush applicator is effective in removing
the outer layer of dry and flaky skin cells, lifting out impurities from within the pores and build-up of debris
from within the folds of fine lines and wrinkles to help smooth the surface of the skin.
The DualClean has been tested for water ingress to the extent covered by IP-X5. This means you can clean
the device under the running tap or using a damp cloth even when the device is switched on. However, it
is not suited for submerging in water or other liquids.
For use in combination with skin care solutions
Apply cleanser, scrub or microdermabrasion cream onto the skin – spread it into a thin layer over the skin
before use. Press firmly to treated area, select mode and move DualClean in an upward, circular motion.
Recommended time per treated area is 30 seconds for each area - forehead, nose, chin and each cheek.
Caring For Your Facial Brush heads
1. Clean brush heads after every use. Remove the brush head, rinse it clean with warm water and mild
soap to remove any build-up that may have accumulated, shake off excess water and towel dry – or
gently rub the brush head against a towel for 5-10 seconds while it is switched on. Do not attach wet
brush heads to the handle while charging.
2. Do not allow liquid cleansers or moisturizers to accumulate on Brush Heads.
3. Replace brush heads as needed – they can be purchased at your local retailer or online at www.silkn.eu.
Caring for your DualClean device
1. Do not use abrasive cleansers or chemicals to clean any part of the DualClean
2. Clean the handle with a damp cloth – using mild detergent or warm water and towel dry immediately
after cleaning.
Disposal
Dispose of the packaging at a recycling point which sorts materials by type.
Products marked with this symbol should not be disposed of along with household refuse!
You are legally bound to dispose of old appliances separately from household refuse. Infor-
mation about where old appliances can be disposed of free of charge is available from your
local authorities.