Polaris 280 Mode D'emploi page 9

Troubleshooting
If the Polaris cleaner displays the following
actions, adjustments may be necessary to
restore performance. Refer to exploded
parts diagram for part references.
Action: Hangs up on steps or other
obstacles for longer than 3
minutes.
Solution: 1. Check the wheel RPM.
2. Verify the back-up valve
3. Adjust the thrust jet.
4. Remove unnecessary pool
Action: Polaris is sluggish, running
with less power than normal.
Solution: 1. Check the filter screen in
2. Clean the skimmer basket,
3. Check all of the hoses,
4. Check the wheel RPM.
Action: Polaris flies around the pool
and/or does not make contact
with the bottom.
Solution: 1. Confirm that the blue
2. Check the wheel RPM. If
is cycling.
hardware or install a Ladder
Guard Kit (order part #G21
from a Polaris dealer).
the in-line filter and clean,
if necessary.
pump basket, and pool filter.
connections, and swivels for
leaks that could cause loss of
water pressure.
restrictor disk is installed in
the UWF to decrease water
flow. Or, install the red
restrictor disk to decrease
water flow even more.
more than 32 RPM, unscrew
the pressure relief valve to
decrease water flow to
the cleaner. Note: The
pressure relief valve should
only be adjusted when a
restrictor is installed.
www.polarispool.com
3. Verify the back-up valve is
cycling. Hold the valve out of
the water and watch the jet. It
should come on and go off.
Action: Polaris does not back up.
Solution: 1. Verify the back-up valve
is cycling.
2. Check the wheel RPM.
3. If the bag is full, empty it.
4. If head float has water in it,
replace it.
5. Make sure feed hose is
floating.
Action: Polaris only turns in one
direction.
Solution: 1. Adjust the thrust jet.
2. Make sure feed hose
is floating.
Action: Feed hose becomes tangled.
Solution: 1. Remeasure the hose to verify
that it is adjusted to the
proper length for the
pool shape.
2. With the Polaris operating,
check that the swivels in
the hose and the hose
connections turn freely.
3. Make sure feed hose
is floating.
4. With the Polaris turned off,
spin each of the wheels. All
wheels should turn together.
Action: Sweep hose is sucked into
the vacuum tube.
Solution: 1. Make sure the opening at the
end of the sweep hose is not
blocked by the sweep hose
scrubber.
2. Adjust the sweep hose to a
gentle sweeping motion.