Safety Tips; Introduction; Pack Contents - Buffalo CD400 Mode D'emploi

UK

Safety Tips

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT feed meat in to the appliance by hand. ALWAYS use the pusher supplied.
• DO NOT use fingers to clear the exit hole while the appliance is turned on.
• DO NOT allow the motor to work against a blockage for any length of time.
• DO NOT immerse in water.
• Only use original BUFFALO parts and attachments with this appliance.
• Always carry the appliance by the motor housing.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified
technician in order to avoid a hazard.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this appliance will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:
• BUFFALO Meat Mincer
• Hopper tray
• Food pusher
• Feed screw
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
1
• Cutting screw
• Cutting plate (coarse - 8mm)
• Cutting plate (medium 6 mm)
• Instruction Manual