Romus TERA Mode D'emploi page 6

GROOVE DEPTH ADJUSTMENT
The depth of the groove depends on
the thickness and the type of flooring:
- For homogenous
linoleum
approximately
thickness of the flooring.
- For non-homogenous PVC's,
groove only the wear layer.
Holding the machine in the down
position, turn the depth adjustment
wheel until the pointer is at the desired
depth setting.
STARTING THE GROOVING MACHINE
Insert the (thin) front wheel in the joint
and align the (wide) rear wheel with the
joint.
Starting: simultaneously
release button (B) and the Start/Stop
switch (A) located under the handle
and keep it depressed.
Slowly push down the handle as far as
it will go. Keeping the handle in this
position, push the "TERA" grooving
6
PVC and
flooring, groove
2/3 of the
press the
GB – « TERA » grooving machine
Adjustment
wheel
First perform some test cuts on flooring
off-cuts.
machine forwards along the joint. After
a few centimetres, the (wider) rear
guide wheel engages in the groove
already created, thus guiding the
machine more firmly.
At the end of each groove, release the
pressure on the handle. A return spring
automatically returns the handle to the
safety position in order to avoid any
risk of accidents.
Shavings collector bag
For maximum vacuuming efficiency,
the bag
approximately every 15 minutes.
The shavings are emptied very easily
by opening the slide on the bag.
should be emptied
Pointer