4.5 LEDs
Power LED
IR LED
LINK LED
Description
LED on
Power LED
Device switched on
LINK LED
Connection established
5. Installation
5.1 Installation set-up
Connect the monitor output on a recorder or video output on a camera to the transmitter. Use the
supplied AV cable and the BNC-RCA adapters.
Connect the receiver to a monitor. Now connect the supplied power supply units to the receiver and
transmitter, then switch them on (move switch from "0" to "I").
Warning:
Please note that the image transmission rate can be limited depending on the ambient
conditions.
Device status display
Transmission/reception of an IR
signal for a remote control
Connection status display
Visual contact
LED flashing
-
Connection being made
19
English
LED off
Device switched off
No connection