U.S.Robotics R24.0506.00 Guide D'installation page 6

Step Two: Configure the Wireless MAXg Router
• Launch a Web browser. In the location or address line of your Web browser, type
http://192.168.2.1 to access the Web User Interface. The Setup Wizard will be displayed.
• Click Start to begin the Setup Wizard procedure.
• Follow the on-screen instructions in the Setup Wizard to configure the basic connection set-
tings of the Wireless MAXg Router. For more detailed Setup Wizard instructions, refer to the
Installation section of the User Guide on the Installation CD-ROM.
Note: Refer to the Installation procedure in the User Guide on the Installation CD-ROM for
more detailed Setup Wizard information. Contact your ISP if you have any questions about
your Internet connection.
Step Three: Verify the Internet connection
When you are finished configuring the basic connection settings, you should have Internet
access. To confirm your connection, launch a Web browser and register your product at
www.usr.com/productreg If the page loads, you are finished with the installation procedure. If
the page does not load, refer to the Troubleshooting section.
Congratulations!
The installation procedure is now complete. You should now have shared
Internet access. If you experience any difficulties, refer to the Troubleshooting section of this
guide or to the User Guide on the Installation CD-ROM for more detailed information.
Note: After you have completed the installation and configuration procedures, it is recom-
mended that you create a backup file of your settings in case you ever experience some dif-
ficulties and want to restore your settings. Perform the following steps:
• Launch a Web browser. In the location or address line of your Web browser, type
http://192.168.2.1 to access the Web User Interface.
• You will be prompted to enter your user name and password. After entering your user name
and password, the Web User Interface will open.
• Click the Device tab and then click Back Up in the Back Up Settings section. Refer to the
User Guide on the Installation CD-ROM for more information about this feature.
2