22
23
24
Start programming the model in the transmitter. Connect all servo cables according to the
transmitter manual and make sure that all servo and rudder are working in right direction. The
recommended control throws are shown in the table. You will get good flying performance with
these throws and the center of gravity shown below.
Function
Aileron
Elevator
55 mm behind the leading edge against the fuselage.
CONTROL THROWS
Normal
▲ 15 mm, ▼ 10 mm
▲ 10 mm, ▼ 10 mm
CENTER OF GRAVITY
Connect the ESC and motor according to the
manual. Fasten the ESC with servotape.
Use the hook and loop tape to secure the batte-
ry in the fuselage. Using the remaining hook
and loop tape and attach theloop portion to the
bottom of the battery. Do not cover safety war-
nings with hook and loop tape.
Install the wings on the fuselage using the two
screws.
Flight Mode
Brake
▲ 20 mm
▼ 2 mm
EN
19