Maintenance - Little Wonder 9811 Manuel D'utilisation Et Consignes De Sécurité

Operating Instructions
Refer to Engine Manual for Engine Operation.
Little Wonder recommends using SAE 30 Oil. The use of
multi-viscosity oil will result in high oil consumption and
possible engine damage.
Leaves, thatch or other debris can be directed into windrows or
piles, by simply maneuvering the unit and directing the flow of
air accordingly.
Air flow can be directed to the side or front by the two-
position deflector. The front discharge position is used to
remove debris from along walls, fences, etc. the side discharge
position is used to form windrows or piles. The horizontal
deflector directs air downward to "chisel" under wet, heavy
leaves and litter. The velocity is regulated by the throttle
control.
Moving the deflector to the upper hole allows for a greater
volume of air to be directed downward. Moving the deflector
to the lower hole allows for a greater volume of air to be
directed upward. To reduce windrowing or to blow over
obstacle, point deflector upward.
Slight changes in deflector will have a big effect on air flow.
Experiment until you find the best position for your needs.
For best performance, be sure engine recoil starter assembly,
the blower intake and outlet areas are clear and free of leaves
or other debris.
Maintenance Instructions
1. Keep all nuts, bolts, and screws tight.
2. Never store the Blower with fuel in its fuel tank
inside a building or in a confined space where fumes may
reach an open flame or sparks.
3. Always refer to the instruction manual for important
details if the product is to be stored for an extended period.
4. Engine - 4 cycle. (Refer to engine manufacturer's operating
instructions for fuel recommendations and additional
information.)
5. Tires - Tubeless. Inflate to air pressure of 30 P.S.I.
6. Labels should be inspected before each use. Replace
damaged labels immediately.
5.
Maintenance Instructions Con't
Check oil level regularly. Be sure correct oil level is
maintained. Check oil level after every 5 hours of operation, or
daily, before starting engine. Use SAE 30 Oil. Change oil after
first 5 hours of operation. Remove drain plug and drain oil
while engine is warm. Replace drain plug. Remove oil fill plug
and refill with new oil. Start and run engine at idle for 30
seconds. Stop engine. Wait 30 seconds and re-check oil level.
If required, add oil to overflowing at oil fill plug.
Directions For Fan Removal:
(This procedure must be done by qualified Little Wonder
dealer)
1. Remove intake guard and front panel.
2. Remove bolt and washer securing fan to engine crankshaft.
3. The fan has a 3/4-16 nut welded on the fan hub. Insert a
3/4-16 grade 5 bolt (or better) and jack or push the fan off
the engine. (Little Wonder part #910515 pressure screw is
recommended.) In some instances, it may be necessary to
apply heat in area of fan hub as Loctite 242 has been used
to secure the fan to the engine crank shaft. Be careful not
to overheat.
4. Use a new bolt (P/N 910508 or P/N 910518) and Loctite
242 to insure a secure fit upon re-assembling.
Wire
To prevent accidental
starting, remove spark plug
wire when servicing engine
or equipment.