Connectable Video Sources; Connectable Audio Sources; Start Up; Settings - Ecler SVA1-5c Notice D'emploi

The DVA1-5c / DVA2-10c operates under voltages between 90 and 264 V at 47 to 63 Hz.
This devices features an over dimensioned power supply that adapts to the mains voltage in any
country of the world with no need to make any adjustments.
The power consumption of the DVA1-5c and DVA2-10c is very low (SVA1-5c no
consumption at all), so they don't need any cooling, but you should avoid extreme temperatures and
the atmosphere should be as dry and dust-free as possible.
In order to protect the unit from an eventual electrical overload it carries a 500mA fuse
(17). Should it ever blow up, unplug the unit from mains and replace it with an identical one. If the
new fuse blows again contact immediately with our Authorized Technical Service. YOU MUST
NEVER USE A HIGHER VALUE FUSE.

3.2. Connectable video sources

ECLERs video accessories accept any composite baseband video signal under one colour
standard (PAL, NTSC or SECAM)
Video Cassette Recorders (VCRs)
The video signal should be taken from the corresponding output and be connected to the
input(s) via a 75 Ohm impedance coaxial cable with BNC connector at the SVA1-5c (7(13)),
DVA1-5c (10) or DVA2-10c (24-21) end. The normalized nominal video level is 1Vpp.
The corresponding audio inputs connect to the RCA sockets (SVA1-5c (9-15(8-14))
DVA1-5c (12-20) or DVA2-10c (26-34) (23-30). The audio connections should be done with shielded
audio cable using RCA (Cinch) type connectors.
Cameras
The connection of video cameras is similar to that of VCRs. It's necessary that the camera
provides separate audio and video outputs.
Monitors and video projectors
The connection is also similar to that of VCRs, connecting video and audio separately.

3.3. Connectable audio sources

Any unbalanced audio signal may be input. This input has a unity gain, i.e. the incoming
audio signal is not modified unless you use the GAIN ADJ control with ±6dB range found on the
DVA1-5c and DVA2-10c.

3.4. Start up

Power up the unit by pushing the switch labelled POWER (6) and the pilot-light inside the
switch will light up, indicating that the unit is functional (DVA1-5c and DVA2-10c)
These units are highly reliable, bear in mind that a not perfect quality may be caused by
poor quality cables.
The DVA2-10c features an extra switch (31) located on the back panel which selects the
operating mode: either 1 input and 10 outputs or 2 x 1 input and 5 outputs independent.

3.5. Settings

These controls let you individually adjust the video (4), chrominance (5) and audio (2-3)
levels inside the DVA1-5c and DVA2-10c. These settings should only be modified by a qualified
technician, with the appropriate measuring instruments.
5