Publicité
Les langues disponibles
Les langues disponibles
User's manual
SAFETY INSTRUCTIONS
• Please keep this User's Manual for future reference. If you sell the unit to another user, be
sure that he also receives this instruction booklet.
• Unpack and check the unit carefully that it has not been damaged during transport before
using the unit.
• Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
• The unit is for indoor use only in a dry location.
• The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
• Disconnect mains power before fuse replacement or servicing.
• Replace fuse only with the same type.
• Make sure there are no inflammable materials close to the unit during operation.
• Use safety cable when fixing this unit.
• In the event of serious operating problem, stop using the unit immediately.
• Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance center
and always use the same type of spare parts.
• Do not touch any wires during operation as high voltage might be causing electric shock.
• To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain or any
moisture.
• If this unit will not be used for a long period of time, disconnect if from power supply.
FEATURES
The D Derby can be DMX512 controlled or work as a stand-alone unit. Several units can be
linked together in master/slave mode or perform the built-in light show program triggered by
music.
INSTALLATION
• The unit should be mounted via its screw holes on the bracket.
• Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating.
• Always ensure that the structure to which you are attaching the unit is secure and able to
support a weight of 10 times the unit's weight.
• Also always use a safety cable that can hold 12 times the weight of the unit when installing
the fixture.
• The equipment must be fixed by professionals at a place which is out of the reach of people
and where nobody can pass by or under it.
Connection to a DMX controller:
The DMX512 signal must be connected to the INPUT and OUTPUT sockets of the unit. Keep
the cable run as short as possible in order to avoid signal losses and interference from other
units. The cable length should not be longer than 100m.
EAGLETONE D DERBY
eagletone.com
EAGLETONE D DERBY
Use a standard 3-pin XLR lead to connect the unit to a DMX controller.
The XLR connector is wired as follows:
XLR male socket
XLR female socket
1. Ground
2. Cold
3. Hot
FUNCTION
CH1: Motor rotation
CH2: Red
CH3: Green
DIAL-UP FUNCTION DESCRIPTIONS
1: ON—rouge
2: ON—green
3: ON—blue
5: ON—fast strobe
6: ON—slow strobe
5,6: ON—all lighting (white)
7: ON—sound control)
8: ON—auto
9: ON—Master slave mode
10: ON—Dial-up function
OFF — DMX function, 1-8 have the function to set the address ID in this case.
TECHNICAL SPECIFICATIONS
Voltage: AC-220V/240V 50/60Hz
Power supply: 40W
LED: 2 x 9W LED RGBW
Working temperature: 20ºC-40ºC
User's manual
XLR Pin Configuration
Pin 1 = Ground
1. Ground
Pin 2 = Data Complement (negative)
Pin 3 = Data True (positive)
CH4: Blue
CH5: Auto
CH7: Strobe speed
eagletone.com
Publicité
