Cleaning, Care & Maintenance - Buffalo CR836 Mode D'emploi

Note: When blending dry ingredients best results will be obtained by cutting
ingredients into small pieces and adding to the blender through the hole in the
lid when motor is running.
Note: Before removing jug, ensure to turn off blender using On/Off switch and
let the motor come to a complete stop.
Cleaning, Care & Maintenance
Always disconnect from power supply before cleaning.
•
• Always allow to cool before cleaning.
• Let the motor come to a complete stop before removing the jug.
• The jug is NOT dishwasher proof!
• Use warm, soapy water and a damp cloth to clean the jug.
Warning: Blade is sharp - handle with care.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.
Warning: Do not allow any water to spill into the body of the appliance when
cleaning.
Troubleshooting
Fault
The unit is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Jug incorrectly located on body of
appliance
CR836_DR825_ML_A5_v2_20200709.indb 5 CR836_DR825_ML_A5_v2_20200709.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Relocate Jug
UK
5
2020/7/9 09:59 2020/7/9 09:59