Using The Pump; Cleaning And Caring For The Pump - Dometic PowerPump PP127 Instructions De Montage Et De Service

PowerPump
6.3 Connecting the pump electrically
CAUTION!
!
Only use cables with the following cable cross section:
 2.5 mm² for cable lengths of up to 6 m
 4 mm² for cable lengths of more than 6 m
➤ Connect the red positive cable and the black negative cable to the 12 or
24 V power supply.
➤ Install a sufficient fuse in the positive cable, see "Technical data" on
page 19.
7

Using the pump

➤ Open the supply point.
✓ The pump automatically turns on and pumps water.
➤ Close the supply point.
✓ The pump automatically turns off again.
8

Cleaning and caring for the pump

WARNING! Danger of electrocution!
!
Always disconnect the mains plug before you clean and service the
device.
NOTICE! Danger of damaging the device!
A
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a damp cloth.
EN
Using the pump
17