Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AHPCS10 POWER CONDITIONER STRIP
FRONT PANEL
1
1.
Circuit breaker: when the total current draw of the switched rear outlets and the front panel unswitched
convenience outlet exceeds 10 amps the circuit breaker will trip. Disconnect one or more pieces of your rack
equipment to reduce current draw. To reset the circuit breaker let it cool for a minute, then push it in gently
until you hear it latch.
2.
Vent: the front panel vent openings provide convection cooling of the AHPCS10.
3.
Unswitched convenience outlet: this IEC outlet is active whenever the AHPCS10's power cord is connected
an appropriate mains outlet. It is not affected by the "Outlets" switch (see 4).
4.
Outlets switch: this activates and disables the rear panel outlets. The red status indicator inside the switch
is lit when the rear outlets are enabled.
REAR PANEL
5
5.
Power cord: connect this to an appropriate mains outlet to power the AHPCS10.
6.
Switched IEC outlets: connect the power cords of your rack equipment to these AC outlets which are activa-
ted by the front panel "Outlets" switch (see 4).
7.
Ground Lug: thumb screw ground terminal.
8
2
6
3
4
7
Publicité
Table des Matières
