Bosch UniversalLamp 18 Notice Originale page 16

16 | English
Cordless worklight
A)
– during operation
– during storage
Recommended batteries
Recommended chargers
A) Limited performance at temperatures <0 °C
The colour rendition of illuminated objects can be distorted.
Fitting
Charging the battery (accessory) (see figure A)
Note: The battery is supplied partially charged. To ensure full battery capacity, fully
charge the battery in the charger before using your tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the Electronic Cell Protec-
tion (ECP). A protective circuit switches the cordless worklight off when the battery is
drained.
The battery features NTC temperature monitoring, which only permits charging in a tem-
perature range between 0 °C and 45 °C. This achieves a long battery life.
Do not continue to press the on/off switch after the worklight has been automat-
u
ically switched off. This can damage the battery. Ensure that the battery is charged
and that the cordless worklight has cooled down before switching the cordless work-
light on again.
To remove the battery (4), press the unlocking button (3) and pull the battery back-
wards out of the cordless worklight. Do not use force to do this.
Follow the instructions on correct disposal.
1 609 92A 4E2 | (06.06.2018)
UniversalLamp 18
°C
°C
PBA 18V...V-.
PBA 18V...W-.
Bosch Power Tools
–10...+40
–15...+50
AL 18... CV
AL 22V..CV