Reinstallation - Aficionado M111 Guide De L'utilisateur

English

Reinstallation:

1. Remove the lower pivot pin from the lower hinge by turning
counter clockwise. (see below)
2. Tilt refrigerator on a 45-degree angle to have access to the
bottom front.
NOTE: Two People Required.
3. Remove both left and right front feet from bottom.
4. Loosen the screws holding the bottom hinge and remove it.
5. Flip bottom hinge 180˚ and align the holes in the bottom hinge to the
corresponding holes on the opposite side of the cabinet. Insert and
tighten the screws. Reinstall both front feet and pivot pin.
6. To install refrigerator door: Line up the left bottom hole of the
refrigerator compartment door over the bottom hinge pin. Move
door forward to make it straight and align with central hinge.
Install the central hinge again, and turn the hinge axle until it
completely enters the door body. Secure it with the screws provided.
NOTE: Remove plugs from doorframe and install on other side.
doorstopper (left side)
middle pivot pin
7. To install freezer door: Line up left bottom hole of the door over the
central hinge middle pin. Move door forward to make it straight
and align with freezer compartment. Place over left side the top hinge,
align holes with hole on the refrigerator top and tighten with the
screws provided.
7
screw holes
central hinge