General Guidelines - Toolland WSG100 Mode D'emploi

Protection Class 2.

Use the soldering gun on a heatproof workbench.

Place the soldering gun in its holder after use.

Let a hot soldering gun cool down naturally and do not immerse in water.

3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Protect this device from shocks and abuse. Avoid brute force when operating the device.

Keep this device away from rain, moisture, splashing and dripping liquids.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Nor Velleman nor its dealers can be held responsible for any damage (extraordinary, incidental or
indirect) – of any nature (financial, physical...) arising from the possession, use or failure of this
product.

Product images are for illustrative purposes only.

Keep this manual for future reference.
4. Features
This soldering gun for fast heat application is equipped with a dual-power heating element. Ideal for all
standard soldering works.

dual-power heater

blow-molded case:
3 different bits
o
solder
o
flux
o
5. Overview
Refer to the illustrations on page 2 of this manual.
1
soldering tip
2
tip connection
3
LED indicator
6. Operation
1. Carefully unpack the soldering gun and check all parts. In the unlikely event that you receive a
damaged device or that parts are missing, please do not use the device and contact your dealer.
2. File off any dirt, rust or paint on the part you wish to solder.
3. Insert the power plug into the mains.
4. Hold the gun by the handle. Hold the trigger pressed for 10 seconds to warm up the tip and release.
5. Place the soldering tip on the point you wish to solder. Hold the trigger pressed and apply a resin-
based solder. Remove the soldering gun and release the trigger. Let the soldering tip cool down and
wait for the solder to harden.
6. Proceed or start again if necessary.
7. Disconnect the soldering gun from the mains and let sufficiently cool down after use. Store in the
original package.
V. 03 – 15/03/2017
WSG100
4
trigger
5
handle
6
power cord
4 ©Velleman nv